Matematicas
Calculadora verificada con fórmula transparente
Area of a Sector Calculator.
Calculates the area of a sector of a circle given the radius and the central angle in degrees or radians.
Tus entradas
Cómo funciona
- 1
Measure the radius of the circle.
- 2
Measure the central angle of the sector in degrees.
- 3
Square the radius and multiply by pi.
- 4
Multiply by the angle and divide by 360 to get the area.
(pi * radius^2 * angle) / 360Preguntas frecuentes
What if the angle is given in radians?
Convert radians to degrees by multiplying by 180/pi, then use the calculator.
Can the angle be greater than 360 degrees?
The calculator allows up to 360 degrees, but for angles beyond 360, the sector would overlap; the formula still works mathematically.
What units should I use for radius?
Any unit of length (e.g., cm, m, inches). The area will be in square units of that length.
Explorar esta categoría de calculadoras
Resultados
Fórmula verificadaEstimación solo como guía general: verifica decisiones importantes con un profesional adecuado.
Cómo funciona
Calculates the area of a sector of a circle given the radius and the central angle in degrees or radians.
- Measure the radius of the circle.
- Measure the central angle of the sector in degrees.
- Square the radius and multiply by pi.
- Multiply by the angle and divide by 360 to get the area.
Fórmulas
Las matemáticas detrás de esta calculadora, escritas para que puedas verificar el resultado.
Area of a Sector
The area of a sector is a fraction of the circle's area, proportional to the central angle θ out of 360°.
Example:
Input: r = 5, θ = 60°
Calculation: (60/360) × π × 5² = (1/6) × π × 25
Result: ≈ 13.09 square units
Casos de uso reales
Dónde aparece este cálculo en la vida cotidiana.
Pizza slice size
Find the area of a slice of pizza given its radius and the angle at the tip.
Example: A 12-inch pizza cut into 8 slices: each slice has angle 45°, area ≈ 14.14 sq in.
Land measurement
Calculate the area of a pie-shaped plot of land.
Example: A plot with radius 100 m and angle 30° has area ≈ 2618 m².
Design and fabrication
Determine material needed for a sector-shaped piece.
Example: A metal sheet sector with radius 2 m and angle 90° requires ≈ 3.14 m².
Consejos y errores comunes
Tips
- Ensure the angle is in degrees; if it's in radians, convert first.
- Use consistent units for radius and area.
- For a full circle (angle=360°), the formula gives πr², the circle's area.
- Round the result to a reasonable number of decimal places for practical use.
Common Mistakes to Avoid
- Forgetting to convert radians to degrees.
- Using diameter instead of radius.
- Not dividing by 360 when using degrees.
Supuestos y limitaciones
- Use the stated inputs and units.
- Results are estimates for planning and education.
- Check measurements and source data before making an important decision.