This calculator is currently shown in English while its translation is being prepared.

Physics

Verified calculator with a transparent formula

Physics

Crane Load Capacity Calculator.

Estimates the safe lifting capacity of a crane based on boom angle, boom length, and rated capacity.

Results update live as you type.
ƒ

Your inputs

How it works

  1. 1

    Enter the crane's rated capacity in tons.

  2. 2

    Enter the boom length in meters.

  3. 3

    Enter the boom angle in degrees.

  4. 4

    The calculator applies the formula to estimate the safe load capacity.

rated_capacity * (sin(boom_angle * pi / 180)) * (10 / boom_length)

Frequently asked questions

What is the safe load capacity?

It is an estimate of the maximum load the crane can safely lift at a given boom angle and length, based on the rated capacity.

Why does the angle affect capacity?

A higher boom angle increases the vertical component of the lifting force, allowing a greater safe load.

Is this calculator a substitute for professional engineering?

No, it provides a rough estimate. Always consult the crane's load chart and a qualified engineer for actual operations.

Explore this calculator category

PhysicsBrowse all

Results

Formula checked

Safe Load Capacity

14.434tons

Ask Anything

Estimate for general guidance only — verify important decisions with an appropriate professional.

How it works

Estimates the safe lifting capacity of a crane based on boom angle, boom length, and rated capacity.

  1. Enter the crane's rated capacity in tons.
  2. Enter the boom length in meters.
  3. Enter the boom angle in degrees.
  4. The calculator applies the formula to estimate the safe load capacity.

Formulas

The math behind this calculator, written out so you can verify the result.

Safe Load Capacity

Safe Load = Rated Capacity × sin(Boom Angle) × (10 / Boom Length)

This formula adjusts the rated capacity based on the boom angle and length to estimate the safe lifting capacity.

Example:

Input: Rated = 50 t, Angle = 60°, Length = 30 m

Calculation: 50 × sin(60°) × (10/30) = 50 × 0.866 × 0.333

Result: ≈ 14.43 tons

Real-world use cases

Where this calculation shows up in everyday life.

Pre-lift planning

Quickly estimate if a crane can handle a load before consulting the full load chart.

Example: Check if a 20-ton load is feasible with a 50-ton crane at 60° and 30 m boom.

Comparing configurations

See how changing boom length or angle affects capacity.

Example: Compare capacity at 45° vs 60° for the same crane.

Training and education

Help crane operators understand the relationship between angle, length, and capacity.

Example: Demonstrate that capacity decreases as boom length increases.

Tips and common mistakes

Tips

  • Always use the crane's load chart for actual lifts.
  • The formula assumes ideal conditions; real-world factors like wind and ground stability matter.
  • Keep the boom angle within the manufacturer's recommended range.
  • Regularly calibrate crane instruments for accurate angle readings.

Common Mistakes to Avoid

  • Using the rated capacity without adjusting for boom length and angle.
  • Ignoring the effect of boom angle on the horizontal reach.
  • Assuming the safe load is the same for all boom lengths.

Assumptions and limitations

  • Use the stated inputs and units.
  • Results are estimates for planning and education.
  • Check measurements and source data before making an important decision.