This calculator is currently shown in English while its translation is being prepared.

Biology & Life Science

Verified calculator with a transparent formula

Biology & Life Science

Species-Area Relationship Calculator.

Estimates the number of species expected in a habitat of a given area using the power-law species-area relationship S = c * A^z.

Results update live as you type.
ƒ

Your inputs

How it works

  1. 1

    Enter the area of the habitat in square kilometers.

  2. 2

    Enter the constant c, which represents the number of species per unit area.

  3. 3

    Enter the exponent z, which describes how species richness scales with area.

  4. 4

    The calculator applies the formula S = c × A^z to estimate the number of species.

c * pow(area, z)

Frequently asked questions

What does the exponent z represent?

The exponent z is the slope of the species-area relationship on a log-log plot. It typically ranges from 0.15 to 0.35 for most habitats, with higher values indicating steeper increases in species with area.

What is the constant c?

The constant c is the number of species expected in one unit of area (e.g., 1 km²). It varies by taxonomic group and region.

Can this calculator be used for conservation planning?

Yes, it helps estimate species loss when habitat area is reduced, which is useful for reserve design and impact assessments.

Explore this calculator category

Biology & Life ScienceBrowse all

Results

Formula checked

Expected species

39,811species

Ask Anything

Estimate for general guidance only — verify important decisions with an appropriate professional.

How it works

Estimates the number of species expected in a habitat of a given area using the power-law species-area relationship S = c * A^z.

  1. Enter the area of the habitat in square kilometers.
  2. Enter the constant c, which represents the number of species per unit area.
  3. Enter the exponent z, which describes how species richness scales with area.
  4. The calculator applies the formula S = c × A^z to estimate the number of species.

Formulas

The math behind this calculator, written out so you can verify the result.

Power-law species-area relationship

S = c × A^z

S is the number of species, A is the area, c is a constant, and z is the scaling exponent.

Example:

Input: A = 100 km², c = 10, z = 0.3

Calculation: 10 × 100^0.3 ≈ 10 × 3.98 = 39.8

Result: ≈ 40 species

Real-world use cases

Where this calculation shows up in everyday life.

Habitat fragmentation

Estimate how many species might be lost when a habitat is reduced in size.

Example: If a 100 km² forest is cut to 10 km², species drop from 40 to about 20.

Island biogeography

Predict species richness on islands of different sizes.

Example: Compare a 5 km² island to a 50 km² island.

Reserve design

Determine the area needed to support a target number of species.

Example: Find the area required for 100 species given c and z.

Tips and common mistakes

Tips

  • Use typical z values: 0.15 for mainland, 0.25 for islands, 0.35 for isolated habitats.
  • Ensure area units are consistent (e.g., all in km²).
  • The relationship is a power law, so log-log plots are linear.
  • For small areas, the estimate may be less accurate due to sampling effects.

Common Mistakes to Avoid

  • Using z as a percentage instead of a decimal (e.g., 0.3 not 30).
  • Forgetting to convert area to the same units as c.
  • Assuming the relationship holds outside the range of observed data.

Assumptions and limitations

  • Use the stated inputs and units.
  • Results are estimates for planning and education.
  • Check measurements and source data before making an important decision.